Product/Service

AJ-4H Performance Specification Sheet

Source: S.I.C. Corp.
The AJ-4H Hauler™ Roll-Off system has one 4.0" bore hook cylinder and uses the same two 6.0" bore lift cylinders that are on the fork system to pick up loads weighing up to 15,000 lb
Front End Fork System

The AJ-4H Hauler™ Fork system lifting and rotating capacity is 10,000 lb (5 tons). This is performed with 6.0" bore lift cylinders, 5.0" bore swing cylinders and 4.5" bore tilt cylinders. The fork system allows the unit to lift the container from the ground and place it completely on the truck with absolutely no over hang and perfect weight distribution. The fork system will then lift the 5-ton container into the desired rotate position with a maximum reach of 15' (forks to ground). This reach will allow front-end containers to be rotated into large Roll-Off containers (40-45 yd) to consolidate loads. Our rotator is designed to rotate containers continuously in any direction a true 5 tons and has only one grease fitting for the rotator bearing. This is the only grease fitting in the system. The rest of the system has space age nylatron greaseless bushing at all hinge points that are far superior than oil impregnated bushings. Out unique folding fork design is the only horizontally folding forks on the market with catch blocks that sustain extreme loads.

Saftey Features
The fork system also incorporates strategically placed non-moving proximity switches that cancel out the Hook Lift system when the Fork system is in use. The back of the swing arm is protected by a trigger plate which cuts out the retract side of the swing arm cylinders and lift cylinders. This prevents the swing arm from being pulled or pushed into the rear of the truck.

Hook Lift System
The AJ-4H Hauler™ Roll-Off system has one 4.0" bore hook cylinder and uses the same two 6.0" bore lift cylinders that are on the fork system to pick up loads weighing up to 15,000 lb (7.5 tons). The base frame has four greaseless traversing rollers that assist the container while in the loading and unloading mode. For dumping loads the AJ-4H does not use the hook to dump, our unique automatic dump lock system locks the container to the dump frame. Then the dump frame raises removing the container from the hook. With two 3.5" bore dump cylinders the AJ-4H has a dumping angle in excess of 50° also with a capacity of 7.5 tons. The dump frame has four lock plates for the container to lock into eliminating container slap while in transport. Small steel blocks 1"x2"x3" get welded to the outside of the hook lift container rails which engange into the lock plates, totally securing the container on the truck.

Safety Features
The hook system also incorporates strategically placed non-moving proximity switches that cancel out the Fork system when the Hook Lift system is in use.

Control Tower:

  • 4 Joysticks (5 fully metering capability)
  • Illuminated Control tower
  • OEM electronic joysticks (fingertip control)

The AJ-4H standard features:

  • Built by Landoll Corporation under agreement with S.I.C.
  • Built under ISO 9001
  • Unit weighs approximately 5,800 lb
  • All units factory installed
  • One year warranty
  • Black POWDER COAT FINISH
  • Ride height 11'3" (tire size and chassis may change ride height)
  • Plastic Minimizer fenders
  • 2800 PSI low pressure system

S.I.C. Corp., 2069 Ninth Avenue, Ronkonkoma, NY 11779. Tel: 631-580-1777; Fax: 631-580-5215.