Drag chainbelt conveyors

All conveyors are shipped complete and ready-to-run unless otherwise stated in the quote.

Conveyor frames are constructed primarily from hot-rolled sheet steel and heavy guage structural steel meeting ASTM A-36 specifications. Curve sections utilize rolled structural shapes for smooth operation and noise reduction. Abrasion-resistant, ultra-high molecular weight (UHMW) polymer strips line all areas of contact between the chainbelt assembly and the steel frame. The polymer strips act as a lubricated surface to reduce friction and lower horsepower requirements. All shafts are minimum 2-15/16" diameter, mounted in type SCM pillow block ball bearings. Conveyor sides are an open design for ease of cleaning and maintenance. When abrasives are in the material stream, 2" vulcanized sidewall will be added to the belt assembly.

Also offered: Heavier duty drag chainbelt conveyors to handle very large material loads to your debaler, pulper or shear.

The Engineering Department of Karl W. Schmidt & Associates, Inc. incorporates all the elements required to provide our customers with the equipment or system which will best suite the unique conditions of their operation. The engineering staff includes the Department Manager, Senior Project Manager, Designers, Electrical Designer and drafting personnel.

Karl W. Schmidt & Associates, Inc. (KWS), 3900 East 68th Avenue, Commerce City, CO 80022. Tel: 303-287-7400; Fax: 303-287-7474.