Nedland Receiver Containers

Nedland Receiver Containers are manufactured in sizes from 21 Cu Yds to 44 Cu Yds and lengths from 14' to 22' Nedland Receiver Containers are backed by Nedlands more than 50 years of Service, Design and Manufacturing experience.

• Floor is 3/16" steel plate with 6"x 2"x 1/4" structural steel tubing with ½"x 2" steel bottom wear bars
• 2" solid bull nose with 45* angle for ease of sliding on rails
• Floor reinforced with 3" structural steel channel on 16" centers with 1/4" gussets floor is extended 3" to support bottom of door
• Body construction is 10-gauge steel plate reinforced with 3/16" steel channels
• Lower body construction is 3/16" steel plate 48" high x 96" long on rear sides
• Side and top support channels are 3/16" steel plate
• All exterior and interior wall to floor joints are continuous weldments
• Tapered front and side walls on body interior
• All side and top support channels have drain holes to prevent rusting
• Four 10" wide x 8" high steel rear rollers with 2" axles and Two 4"x 4" solid steel front rollers with 1½" axles all with grease fittings
• Door construction is 10-gauge steel plate and reinforced with 2"x 3"x 3/16"structural steel tubing and cross beams
• Door latch located on drivers side of container for maximum safety and is a ratchet locking system
• Door hinges are heavy duty 11/4" x 14" (Piano) type hinge assembly with grease fittings
• Pull plate 3/4" with 1½" reinforced hook and ½"x 2" sag bar
• Also constructed to fit Ampiroll, Stellar American Hook Lift, Multi-Lift Vulcan Swap-Loader and Dead Lift
• All containers are Phosphotized cleaned and primed to 1.5 mil and painted to 1.5 mil on all interior and exterior surfaces

Nedland Industries Inc., 417 Railroad Street, Ridgeland, WI 54763. Tel: 715-949-1982; Fax: 715-949-1983.